It rattles/jingles too!

Pineap-PAL done

Finished the leaves that‘s a lot of sewing!

Yey! Done with the pineapple

I removed the plastic container and just put in the ball with bell, because it‘s diffucult to close with the container inside and the noise is driving me crazy

I think I made a big one with too much hallow space...so I decided to stuff it with an empty plastic container (reused from q-tips/toothpick container, and placed a ball with a bell inside....so now, my Pineap-Pal is also a rattle!

There was a correction made for 1A, I finally understood clearly what should have been done...I realized that I‘ve probably botched up rows 1 and 2 but I‘m already too far along to want to start over again...sooooo I‘ll jist keep going and hope that I haven‘t botched it up too much

I undid everything I did before because I thought it was too hole-y, I was worried the polyfiber fill might not stay inside later...i sized down to 3.5mm hook. It now looks tighter, with less big holes

Oooh I get it! Look at the dcs as a pair of V dcs and don‘t think about the location

After several tries, I‘ve finally got it i got confused at first and 5dc-ed into the wrong dc. After trying this way and that, I finally figured out to skip the 3ch and then 5dc into the first actual dc, ch1, and then 5dc into the next dc (that inner V of the 2dc, 2ch, 2dc of the previous row) and then, sl st into the space between the next 2 dc

Ehm...I‘m not sure if I‘m doing things right, but I‘ll just trust the process in the meantime

Now minus the first dc in the same stitch after the ch3, it now has 3Vs needed

I‘m confused by the extra dc in 1A...redoing it to omit the first dc as ch3 is counted as dc