Added in the hooks and stitch markers! Once I‘ve got the drawstring done I think it‘ll be complete! Hooks I‘ve added are 7mm, 6.5mm, 6mm, 5.5mm, 4.5mm, and 3.5mm

Got the star and pocket sewn on!

Made the second part of the pocket, still have to make and attach the star, then sew the pocket on. I think I hopefully should be able to finish the case tomorrow!

Made & attached the top part of the pocket!

Finished the first part of the large pocket, feeling good!

Both of the pockets for the left side have been completed and sewn on! One of the pockets is a little crooked, but overall I think it‘s looking pretty good!

Today I finished remaking the base of the case! The granny square pocket fits much better now, and so do the hooks. For the remake, I followed the pattern according to the stitch/row count as opposed to the measurements. The original case is 7”x12” and the remake is about 10”x15.5”

So here‘s where we‘ve started to run into some problems with the sizing... I had adjusted the stitch count for the base panel of the case to match the measurements given, but didn‘t think to do the same for the granny square until after it was complete. Not only is the granny square too big, but looking at the case itself it doesn‘t quite line up with the pattern image in terms of the hook-to-case ratio. Tl;dr I have to start over entirely

Finished the border! It took me a little while to figure out how to do it, but I think it turned out well!

Finished the first panel!